PKT Hammer-in Anchor

The Prudential hammer-in anchor achieves mechanical anchoring through inward expansion. Compact and easy to install, it suits small post-installed fixings in concrete.

Product Certification：
Load capacity report / Material analysis report

Scope of application：
Mainly used for light to medium loads: ceiling hangers, small pipe supports, decorative elements and protective fittings.

Product Advantages

Internal expansion, stable and reliable anchoring

An internal cone drives the sleeve open into a mechanical interlock. Expansion forces are even and the sleeve grips the hole wall tightly, providing stable pull-out and shear capacity for MEP supports, guardrails and small steel structures.

Small hole diameter, less substrate damage

A smaller drill hole means less damage to the concrete than conventional external-expansion anchors. Can be installed at tight edge distances and beam sides without chipping or cracking the wall.

Simple operation, ideal for confined spaces

No external nut tightening is needed — a single hammer blow on the cone locks the anchor. Fully zinc-plated and compact, it suits narrow spaces where there is no room to tighten from the outside.